C1005 Code: Meaning, Causes, and Symptoms | OBD2 Codes
C1005 – Status Lamp Failure BCM Signal Invalid
C1005 Possible Symptoms
Anti-Lock Brake System (ABS) Warning Light ON,Engine Light ON (or Service Engine Soon Warning Light)
C1005 Possible Causes
Faulty Instrument Panel Cluster (IPC),Instrument Panel Cluster (IPC) harness is open or shorted,Instrument Panel Cluster (IPC) circuit poor electrical connection
C1005 Description
The Electronic Power Steering (EPS) system employs a column-mounted electric power steering unit along with a manual steering rack and pinion to provide a variable power-assisted steering with reduced parasitic engine load. The EPS controller monitors two steering wheel position sensors to determine the absolute position of the steering shaft and determines driver input via a steering wheel torque sensor. In addition, the EPS controller uses four hall-effect position sensors to monitor the absolute and commanded position of the motor. The EPS controller obtains vehicle speed, alternator output, and steering mode information, and broadcasts warning lamp status and service diagnostic information, on CAN C. During normal driving, as the driver turns the wheel, the torque sensor value changes based on the effort the driver uses to turn the wheel. The controller uses this information, along with the steering wheel absolute position and vehicle speed, to determine the amount torque required from the motor. Voltage is then provided to the motor to provide power steering assist. If the Body Control Module (BCM) detects an EPS status lamp failure, this C1005 code will set.