P1CEA FIAT – Boost Side EVAP Purge System Performance

P1CEA FIAT Possible Symptoms

Engine Light ON (or Service Engine Soon Warning Light)

P1CEA FIAT Possible Causes

Faulty Fuel Tank Pressure Sensor,Faulty Purge Solenoid,Fuel Tank Pressure Sensor harness is open or shorted,Fuel Tank Pressure Sensor circuit poor electrical connection,Faulty Powertrain Control Module (PCM)

P1CEA FIAT Description

The Evaporative Purge Monitor tests the integrity of the hoses/tube between the throttle body/intake and the fuel tank. At key off, the Powertrain Control Module (PCM) monitors the Evaporative System Integrity Monitor (ESIM) Switch. As the fuel and air in the Fuel Tank cools, a vacuum will occur naturally inside the tank. One inch of vacuum will cause the switch to close. If the PCM sees the switch close before the counter reaches a calibrated amount, the monitor passes. The monitor is a two stage test and runs only after the Evaporative system passes the small leak test. Stage one is non-intrusive. With the engine running, the monitor will first evaluate the delta pressure change of the Fuel Tank Pressure (FTP) Sensor while normal purge control is active. If the monitor does not pass within a calibrated amount of time, then an intrusive monitor will be enabled. The intrusive test runs only if stage one does not pass. This intrusive monitor will ramp in the purge flow to a target amount while evaluating the delta pressure in the entire system. If the delta pressure between purge off and purge on exceeds a calibrated amount, then the monitor will ramp out the purge flow and evaluate the delta pressure between the high flow and the new low flow target. If the delta pressure is less than a calibrated threshold then the monitor will pass.