OBD2 Codes

This site is supported by nonda.co. As a smart vehicle devices provider, nonda helps create a better driving experience for everyone.

Categories

,

P2195 2010 HONDA ACCORD Code: Meaning, Causes, and Symptoms | OBD2 Codes

P2195 2010 HONDA ACCORD – Rear A/F Sensor Sensor 1 Bank 1 Signal Stuck Lean

 

P2195: DIY Repairing Video Tutorial

https://youtu.be/uNnGIoAzI6U

Check out nonda Auto DIY Center for more engine error code repairing videos.
https://www.youtube.com/playlist?list=PL-Lyko0O0oxHe1AGvzwAz-wokJPXAtW97

 

P2195 2010 HONDA ACCORD Possible Symptoms

  Engine Light ON (or Service Engine Soon Warning Light),Excessive Fuel Consumption  

P2195 2010 HONDA ACCORD Possible Causes

  Rear A/F Sensor Sensor 1 Bank 1 harness is open or shorted,Rear A/F Sensor Sensor 1 Bank 1 electrical circuit poor connection,Faulty Rear A/F Sensor Sensor 1 Bank 1,Vacuum leak,Low fuel pressure  

P2195 2010 HONDA ACCORD Description

  Air-Fuel Ratio (A/F) sensor need to reach a minimum operating temperature of 1200 degrees F to produce an accurate voltage signal. The faster the air-fuel ratio sensor reaches that temperature the faster the sensor will start sending an accurate signal to the Engine Control Module (ECM). In order to achieve the require temperature, a heater element is included inside the air-fuel ratio sensor. The ECM controls the air-fuel ratio sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground. The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.      

Leave a Reply

Discover more from OBD2 Codes

Subscribe now to keep reading and get access to the full archive.

Continue reading